1.    Surface Preparation
Use a tape measure or ruler to determine the exact area where the quote/graphic will be placed. It is a good idea to draw a horizontal line, or use masking tape or painters tape for a guide. Make sure your surface is clean and smooth.
The vinyl can be installed just about anywhere you want to put them.  Painted walls (light and medium texture work fine, including knock down and orange peel) ,wood, furniture, ceramic tile, metal, glass, porcelain, painted brick, wallpaper,
bathroom sinks, showers, doors, hardy plank, mail boxes, and much more.

2.    Prepare Quote
Some quotes/graphics will come rolled up because of the length. Unroll and let it sit flat until it stops trying to roll itself up again. The vinyl is sandwiched between transfer tape and backing. You want the vinyl to stick to the transfer tape.
Before peeling the back paper off, turn the phrase so it is facing down on the surface and then burnish (rub) the surface of the transfer tape to ensure the vinyl is adhered solidly to the transfer tape. (letters may pull away from the transfer tape during shipping)

3.    Application
Flip the quote/graphic over and carefully peel the backing away from the quote on an angle, which should remain on the transfer tape. If some of the vinyl lettering sticks to the backing or starts to float away from transfer tape, replace the backing or place it back in its original place and the vinyl lettering and rub it again so it sticks to the transfer tape or the top side thinner paper where you read the phrase or words. 

Place the taped vinyl on the prepared surface using your guide or tape to position your vinyl correctly. *The quote cannot be repositioned once it is on your surface, so be careful to line it up where you want it.

4.    Burnishing
Using the application stick or credit card carefully and press any air bubbles out from underneath the words. Burnish again and apply more pressure over the entire area.

5.    Transfer Tape Removal
CAREFULLY peel back the transfer tape on an angle leaving the vinyl on your surface, If the vinyl tried to come up with the transfer tape, place the tape back on the surface and burnish that area again until the vinyl sticks to your surface.

6.    Enjoy your vinyl design creation!
 

Vinyl Removal
Removal of your Quotes/Graphics is easy: use a blow dryer on a low setting over the vinyl and peel them off the surface.

Peel-n -Stick Products: Make sure your surface is clean of dust and dirt and then just Peel-n Stick. It's that EASY!